Employee Login
  Products Knowledge Centre Downloads Clients Support Careers Research Contact Us
 
 
 
Home > Products > Safety
M-63 Safety Features
Your safety is our responsibility.
CE: The “CE” marking is an abbreviation for European Conformity
The CE marking is neither a mark of origin nor a quality mark, this marking symbolizes conformity of the product to all of the applicable EU safety, health, and environmental requirements.

EN61010-1:2010: This revised edition provides a presumption of conformity with the Low Voltage Directive (LVD) and is also essential for compliance with Health and Safety at Work. This standard aims to ensure the safety of anyone that uses this type of electrical equipment for measurement, control, and laboratory use.

EN 61326 - 1:2006: specifies requirements for immunity and emissions regarding electromagnetic compatibility (EMC) for electrical equipment, operating from a supply or battery of less than 1000 V AC or 1500 V DC. or from the circuit being measured, intended for professional, industrial-process, industrial-manufacturing and educational use, including equipment and computing devices for measurement and test, control, laboratory use.

1000V overload Protection: 1000V overload protection makes your DMM compatible to work even in high voltage areas. This protection is important, as in case of high voltage if your DMM is without overload protection, then the DMM will get damaged and there is a chance that it might be hazardous to your safety also.

CAT-IV/600V: The International Electro technical Commission (IEC), an organization that develops safety standards, defined the standards for Category IV environments. This category is applied to the source of the building’s electrical installation: the entrance service panel, the primary mains meter, or perhaps the secondary side of the building distribution transformer, if the transformer is located within the building. So ensure your DMM is CAT IV protected before using it in the mentioned areas.

IP-54 protection: Ingress Protection rating is used to specify the environmental protection ‐ electrical enclosure ‐ of electrical equipment.

IP-54 indicates: Protected against dust limited ingress (no harmful deposit), and Protection against water sprayed from all directions ‐ limited ingress permitted.

Now with M63 you can be confident about your safety.
 
Related Links
Download Catalogue
View Demo
Calibration Certificate
  Note-Please turn off pop-up blocker to view demo.
An ISO 9001:2008 Company. Copyright 2010-2020, all rights reserved.
Best viewed in Internet Explorer 7.0 & above. |  Last Updated : 02/2014